This content contains affiliate links. If you purchase anything through the links a small percentage goes to the writer at no cost to you.
Resin
Resin– there are so many options when purchasing resin it really depends on what you want to make. For basic items and a clear see-through finish there is a basic option for under £18 and if you are more interested in mixing colors there is one for under £20
When using the epoxy ensure you have gloves and a mask as well as a clear area that can get dirty. Chances are you will spill some resin as one point, don’t let it be on your kitchen worktop, its a nightmare to remove!
Also mixing your resin is the crucial point where it can go wrong. Make your measurements as exact as possible measuring in volume not weight. Most of the basic epoxy are a 1.1 ratio.
Mix until the swirls are gone and the resin is clear, usually 2-3 minutes.
While pouring the epoxy ideally use layers, especially if it is large amounts as this can get too hot and not set properly.
Moulds
This also depends on what you want to make, however if you aren’t sure a basic general kit is a great place to start. The shape moulds have pyramid and diamond shapes and you cant go wrong. Try not to overfill the moulds as you will then have to file it down afterwards.
Also you don’t have to use moulds you can be creative and use shells, or other items that will hold the resin without leakage. if you are planing to use glass or a container that isn’t made of silicone be aware that it will stick to the sides and is not completely practical.
Pouring and set
You can add any amount of items to your moulds before filling with resin, just ensure they are clean and fit neatly within your moulds. Also stay away from foods that aren’t dehydrated and anything containing water no matter how minimal.
When pouring your resin do so in small amounts and once you are satisfied use a small lighter or mini blow torch on a low heat if you have one to remove the bubbles.
You don’t want to heat the resin up too much as it wont set properly afterwards, oh and it can catch fire.
Be sure to wait the time stated in your instructions for your work to set fully and then de-mould.
You can sand any pieces after they have set and polish for a clear finish.
Happy moulding!
Don’t fancy epoxy resin you could try: